Tips how to generate correct GS1-128 (EAN128) barcodes

Knowledge exchange related to the VPE Report Engine and PDF Library

Moderator: IDEAL Software Support

Tips how to generate correct GS1-128 (EAN128) barcodes

Postby Jean-Pierre Leroy » Tue Mar 31, 2020 9:35 pm

Dear VPE users,

I'm happy to share with you some useful tips I use in order to generate correct GS1-128 (EAN-128) with VpeBarCode() function and BCT_EAN128 code type.

One crucial point is where to place the control character FNC1, depending on the Application Identifier (AI)

The 4 rules where to place the control character for a GS1-128 (EAN-128) barcode are the following ones :

1. Add the FNC1 character only for variable length AI, before the next AI to close the current AI.
2. Do not add the FNC1 character for fixed length AI.
3. Add the FNC1 character only for AI located in the beginning or in the middle of the bar code.
4. Do not add the FNC1 character for the last AI (even if it's a variable-length AI).

Example:

AI (01) is always 14 digits, so I don't have to add the FNC1 character.
AI (10) is between 1 to 20 alphanumeric car, so I have to add the FNC1 character at the end of the data (235590201).
AI (37) is between 1 to 8 digits, so it should have normally the FNC1 character, but the last AI in the bar code must not be followed by the FNC1 character.

So the correct string is "(01)12345678901234(10)1234<FNC1>(37)12"

With VPE, you should removed the parentheses:
VpeSetBarcodeAutoChecksum(hDoc, TRUE); VpeBarcode(hDoc, lCoordX+17.50, lCoordY+16.00, -10.20, -3.00, BCT_EAN128 , "011234567890123410ABCD<FNC1>3712","");

PS: VPE does insert a control character FNC1 at the beginning of the string when BCT_EAN128 code type is used, so you don't have to add one by yourself.

More info :

https://en.wikipedia.org/wiki/GS1-128
https://www.gs1.org/standards/barcodes/application-identifiers

Hope that could help someone.

Regards,
Jean-Pierre Leroy
Jean-Pierre Leroy
 
Posts: 1
Joined: Thu Jul 28, 2016 1:28 pm

Return to VPE Open Forum

Who is online

Users browsing this forum: No registered users and 6 guests